NM Engineering 658856.2 User Manual

Page 2

Advertising

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX

engineer@nm-

eng.com ∞ www.nm-eng.com

10. Install NM SS bracket onto factory air filter box mounts.

NOTE: Make sure rubber grommets are still in place and not
attached to bottom of the OE air filter box. From bottom side
of mounts, install and tighten using supplied M8 washers and
M8 lock nuts. [13mm socket and wrench]

11. Remove protective film from double-sided tape on stainless

steel fresh air hose bracket. Slide bracket down between
ECU and black plastic ECU mount, while keeping double
stick tape from touching. With bracket pushed all the way
down, press against ECU.

12. Attach brake booster line holder to forward mounting hole in

bracket. Secure fresh air pipe to rearward mounting hole
using supplied M6 x 10mm button head bolt. [4mm hex key
wrench]

13. Reconnect MAF sensor electrical connector.

14. Install and tighten silicone coupler onto MAF sensor using

supplied #44 hose clamp.

15. Remove factory breather hose from original air intake. Insert

tube adapter (rolled lip end) into silicone turbo inlet hose and
tighten with supplied #16 hose clamp. Connect breather hose
onto tube adapter.

16. Loosely install silicone turbo inlet hose onto turbo using

supplied #28 hose clamp. NOTE: Do NOT tighten at this
time.

17. Loosely install supplied #44 clamps onto both silicone hose

ends, then install air intake pipe into silicone turbo inlet hose
first and then into MAF sensor hose. Adjust as necessary for
clearance, paying close attention to clearance of silicone
turbo inlet hose and coolant reservoir bottle. Tighten all
clamps. NOTE: Do not forget to tighten #28 hose clamp from
Step 16. Connect breather hose to cylinder head cover.

18. Using a degreaser or contact cleaner and shop rag, Clean

inner mounting flange of NM filter. Install NM filter onto MAF
sensor and tighten with long skinny screwdriver thru logo cut-
out or from back side of bracket.

19. Double check complete installation. Test drive and double

check all connections.

Advertising