NM Engineering 658857 - Manual (Page 2)

NM Engineering ∞ 3300 Corte Malpaso, Camarillo, CA 93012 ∞ 805.388.7171 ∞ 805.388.0030 FAX
[email protected] ∞ www.nm-eng.com
9. Remove protective film from double-sided tape on stainless
steel fresh air hose bracket. Slide bracket down between
ECU and black plastic ECU mount, while keeping double
stick tape from touching. With bracket pushed all the way
down, press against ECU.
10. Attach brake booster line holder to forward mounting hole in
bracket. Secure fresh air pipe to rearward mounting hole
using supplied M6 x 10mm button head bolt. [4mm hex key
wrench]
11. Slide MAF wire harness rearward where it attaches with wire
tie at turbo intake tube.
12. Reconnect MAF sensor electrical connector.
13. Install and fully seat NM connection pipe (non-beaded end)
into turbo intake tube then tighten using 7mm nut driver or
screwdriver.
14. Loosely install supplied #44 SS hose clamps onto NM
silicone hose. With NM logo on silicone hose facing firewall
install onto NM connector first then onto MAF sensor.
15. Tighten SS hose clamps using 8mm nut driver or
screwdriver.
16. Using degreaser or contact cleaner and shop rag, clean inner
mounting flange of NM filter. Install NM filter onto MAF
sensor and tighten with long skinny screwdriver thru logo cut-
out or from back side of bracket.
17. Double check complete installation. Test drive and double
check all connections.
©2011 NM Engineering, a division of Automotive Performance Systems, Inc.
All rights reserved. Reproduction in whole or in part is prohibited.
DOC. NM.658857 Rev. 04.01.11