NORAC UC4+BC+HD5 Part 1 User Manual
Page 22
18
c) Insert the blue-wire harness into the 37-pin DB male socket on the other side of the PCB of
C12A. Screw it down to the socket.
Do not connect spade connectors to J1&J2 until step 9.
9. Run the free end of C12A through an unused hole of the electronics enclosure. This requires
installing the Liquidtight connector (Pt. HARDI04, HARDI05) BEFORE proceeding to step 8.
10. Put pins of C12A to the 6-pin and 4-pin Weatherpack connectors (S6 and S4) which are included in
this kit according to the table below. One connector on harness C11 may by unused. Seal the
unused connector with a 6-pin Weatherpack plug (part #).
The wire colors and the pin-out are the same as ones on the mating connectors (T6
and T4) of the extension cable (C11).