Casio DT-X5 Series - Manual (Page 38)

E-36
Using the Laser Scanner
(DT-X5M10E/DT-X5M10R only)
1. After turning on the power, position the
laser scanner close to a bar code and then
press the Trigger key (R or L).
2. The laser emits light and scans the bar
code. If scanning is completed normally,
Indicator 2 displays a green light and a
buzzer sounds. Indicator 2 displays a red
light when an error has occurred during
reading.
Important!
• If you are unable to scan a bar code, try changing the angle at which the scanner
is held or distance from the scanner to the bar code, and then try scanning again.
• This Handheld Terminal is capable of scanning bar codes at a distance of 0~
400 mm. Furthermore, the distance at which scanning is possible may vary
according to the symbology.
• The laser scanner models are not available in the USA and Canada.
DT-X5_E_P36_48.p65 04.9.2, 9:45 AM 36