Philips TP2780C - Manual (Page 29)

U sing the R emote ' s VCR B uttons
W hen using the TV rem ote
with a VCR, first make cer­
tain it is set to control your VCR
(by the REM OTE CODE or
SEARCH m ethod - see earlier
section),
t BEGIN]
Press the VCR System but­
ton on the remote.
<P
I
<|>
Point tli^ top of the remote
toward the front of the VCR
(remote seni.or window) when
pressing buttons.
Record (Clear) Button
Hold the RECORD button down, and
then press the PLAY button to begin
a VCR recording. The CLEAR button
can be pressed to erase incorrect data
when programming VCR functions.
The Clear button can also be pressed
to reset the VCR’s real time counter.
Rewind Button
Press to rewind tapes. For some
VCRs you may need to press STOP
button first then REWIND. In play­
back mode hold button down to view
picture moving rapidly in reverse.
Pause Button
Press to temporarily stop the tape
during a playback or recording. Press
again to release Pause.
TV-VCR Button
Press to the VCR position ("VCR"
indicator on the VCR will light) to
view the playback of a tape. Press
again to place in the TV position
("VCR" indicator on the VCR will go
OFF) to view one program while
recording another program.
When used with the TV the TVA^CR
button worlS as a source button.
Each press cycles the TV between
channels 3 and 4; or the VCR/AUX
Input mode. It is a quick one-button
way to select these channels and
modes (without directly entering the
TV's Menu system.)
o
Pi
VOL CH
loJ loJ
(ON/OF f I i POS P j SWAP 11 FREEZE )
PIPC EUD
Play Button
Press to playback a tape. Hold down
after pressing the RECORD button to
start a recording.
■Stop Button
Press to stop the tape.
Fast Forward Button
Press to rapidly advance the tape. For
some VCRs you may need to press
STOP first then FF. In Playback
mode hold button down to view the
picture moving rapidly in the forward
direction.
Channel Scan Buttons
Press to scan up or down through
VCR channel numbers.
Number Buttons
Press buttons for direct VCR channel
selections.
VCR System Button
Press to send remote commands to
the VCR.
Power Button
Press to turn the VCR ON and OFF.
Remember, the VCR but-
M . tons on the remote will not
operate your VCR if those fea­
tures are not already found on
your VCR remote control.
Note: All VCR functions (particu­
larly Search, Rewind, Fast
Forward, etc.) will operate the
same as with the original VCR
remote control provided with the
VCR.
29