Campbell Hausfeld IN729800AV - Manual (Page 11)

Operating Instructions and Parts Manual
www.chpower.com
CHN71600
11
The stapler should be stored in a cool dry location.
Maintenance
ClearINg a jaM FroM tHe StaPler
1. Disconnect stapler from air supply.
2. Remove all fasteners from the magazine (see Loading/ Unloading). Failure to do so
may cause the fasteners to eject from the front of the stapler.
3. Press magazine latch (see Loading / Unloading the Stapler).
4. Open the magazine, exposing the jammed fastener.
5. Remove the jammed fastener, using pliers or a screwdriver if required.
6. Load with staples.
7. Make sure the trigger moves freely without sticking or binding.
StaPler rePaIr
Only qualified personnel should repair the tool and they should use genuine Campbell
Hausfeld replacement parts and accessories, or parts and accessories which perform
equivalently.
rePlaCeMeNt PartS
Use only genuine Campbell Hausfeld service parts. Tool performance,
safety and durability could be reduced if improper parts are used. When
ordering replacement parts, specify by part number.
aSSeMbly ProCedure For SealS
When repairing a stapler, the internal parts must be cleaned and lubricated. Parker
O-lube or equivalent must be used on all o-rings. Each o-ring must be coated with
O-lube before assembling. A small amount of oil must be used on all moving surfaces
and pivots.
teCHNICal ServICe
For information regarding the operation or repair of this product, please call
1-800-543-6400.
FaSteNer INterCHaNge INForMatIoN
Fasteners used in the Campbell Hausfeld CHN71600 3/8 inch Stapler include:
• Arrow ® T50 ® staples or any equivalent fastener with the approximate dimensions
illustrated in Figure 10
Storage
Figure 9
Figure 10
10.7 mm
6
mm - 14
mm
1/4 inch - 9/16 inch
1.3 mm
0.7
mm
9.3 mm