Chief Manufacturing Truss/Pole Static Mount TPS-2000 Series - Manual (Page 4)

Model: TPS-2000 SERIES Installation Instructions
4
Figure 5: Install Truss Plate to Truss
Install Face Plate to Truss Plate
1. Verify face plate (20) is properly oriented for
installation. (See Figure 7)
Figure 6: Face Plate Orientation to Truss plate
2. Install two .64" x .327" Nylon Spacers (60) onto
mounting studs on face plate (20) back.
3. Align mounting studs on face plate (20) with center
upper mounting hole and lower center slot in truss
plate (10). (See Figure 7)
4. Place studs on face plate back into, and through,
center upper mounting hole and lower center slot in
truss plate (10).
5. Secure face plate (20) top to truss plate (10) using
one 3/8" flat washer (40), and one 3/8" Nylock Nut
(30).
Figure 7: Install Face Plate to Truss Plate
6. Secure face plate (20) bottom to truss plate (10) using
one UHMW Washer (50), one 3/8" flat washer (40),
and one 3/8" Nylock Nut (30). (See Figure 7)
DISPLAY INSTALLATION
WARNING: DO NOT attempt to hang display on stand
with one person.
1. Make sure Q-Latch is in the OPEN position so it will
not obstruct display installation (See Figure 8).
Figure 8: Open Q-Latch
2. With one person supporting each side of the display,
align the four mounting buttons with the four teardrop
slots in faceplate (See Figure 9).
10
Truss
Clamp with Hardware
(4 places)
To Display
Back Plate mounted
on pole or truss
Side with part number decal
towards back plate
To
Back Plate
UP
Mounting Stud
Mounting Stud
Nylon Spacer (60)
Face Plate (20)
TrussPlate (10)
(Mounted to Pole
or Truss)
Flat Washer (40)
Lock Nut (30)
Flat Washer (40)
Nylon Spacer (50)
Q-Latch
Faceplate
Display
OPEN