Philips CDC751-17 - Manual (Page 2)

FITTIIMG A MAINS PLUG (U.K. only)
This apparatus is fitted with an
approved moulded 13 Amp plug.
To change a fuse in this type of plug
proceed as follows;
• Remove fuse cover and fuse.
• Fix new fuse which should be a
BS1362 5A, A.S.T.A. or BSl
approved type.
• Refit the fuse cover.
If the fitted plug is not suitable for your
socket outlets, it should be cut off and an appropriate plug
fitted in its place.
If the mains plug contains a fuse, this should have a value of
5A. If a plug without a fuse is used, the fuse at the
distribution board should not be greater than 5A.
NOTE
The severed plug must be disposed to avoid a possible
shock hazard should it be inserted into a 13A socket
elsewhere.
HOW TO CONNECT A PLUG
The wires in the mains lead are coloured in accordance with
the following code:
BLUE - “NEUTRAL“ ( N") and BROWN - ' LIVE ‘ ( L)
As these colours may not correspond with the colour markings
identifying the terminals in your plug, proceed as foilow'S'
• The BLUE wire must be connected to the terminal which is
marked with the letter' N" or coloured BLACK.
• The BROWN wire must be connected to the terminal which
is marked with the letter “L' or coloured RED.
• Do not connect either wires to the earth terminal in the plug
which is marked by the letter' E" or by the safety earth
symbol or coloured green or green-and-yellow.
Before replacing the plug cover, make certain that the
cordgrip is clamped over the sheath of the lead - not simply
over the two wires