Philips 27PT541S - Manual (Page 8)

B asic C able B ox /D ecoder C onnection
/ Jyou cable signal uses a cable box or
decoder, follow the easy steps below to
complete the connection.
Cable Box (w/RF In/Outputs):
This connection will NOT supply Stereo sound
to the TV. The sound from the cable box will
be mono.
■ Connect the open end of the round
Cable Company supplied cable to the
cable signal IN(put) plug on the back
of the Cable Box.
2 Using a separate round coaxial cable,
connect one end to the OUT(put) (TO
TV) plug on the back of the Cable
Box.
3 Connect the other end of the round
coaxial cable to the 75Q input on the
back of the television. Screw it down
finger tight.
NOTE: Be sure to set the OUTPUT CHAN­
NEL SWITCH on the back of the cable box to
CH 3 or 4, then tune the TV to the correspon­
ding channel. Once tuned, change channels at
the cable box, not the television.
Cable Box (w/Audio/Video
Outputs):
This connection will supply Stereo sound to the
TV.
4
Cable Box Connection (RF Input/Output Only):
Cable Signal
IN from the
Cable
Company
CABLE
IN
Jack Panel Back of Cable Box
OUTPUT
CH
lBi~l
3 4
1—1
riz:
[•4
Round 75Q
Coaxial Cable
Jack Panel Back of TV
Cable Box Connection (with Audio/Video Outputs):
Cable Signal IN from
Connect the open end of the round
Cable Company supplied cable to the
cable signal IN(put) plug on the back
of the Cable Box.
5 Using a RCA type Video Cable, connect
one end of the cable to the Video (or
ANT, your cable box may be labeled dif­
ferently) Out jack on the cable box and
the other end to the AVI Video Input on
the TV.
6 Using a RCA type Audio Left and Right
Cable, connect one end to the left and
right Audio Out L & R jacks on the
cable box. Connect the other end to the
AVI Audio L & R Input jacks on the TV.
NOTE: Use the Channel +, or - buttons on the
TV remote control to tune to the AVI channel
for the cable box signal. Once tuned, change
channels at the cable box, not the television.
8