Philips G470-30 - Manual (Page 7)

Table 1. Beard Trimmer
Setting Remaining hair length
(In.) /(mm)
1 Stubble 5/64 in/2mm
2
Closely Cropped 5/32 in/4mm
3 Short 1/4 in/6mm
Medium Short 5/16 in/8mm
5 Medium 13/32 in/10mm
6
Medium Long 5/32 in/12mm
7 Long 9/16 in/14mm
8
Extra Long 5/8 in/16mm
9 Longest 23/32 in/18mm
I The remaining hair length corresponds with
the smallest distance between the cutting blade
and the spot where the comb is in contact
with the skin.
k Cutting without the comb attachment or
setting the AccuControl guide comb to #1
position will result in a stubble beard look.
Beard Trimming Without
AccuControl Comb
Remove comb if you are:
k Defining hair lines
I Trimming nape of neck
i
Removing single, unwanted hairs
U Be certain the Groomer is in the OFF
position.
Q Remove the AccuControl comb attachment
by pressing and sliding the Hair Length
Selector upwards (fig. 7).
Never pull off the AccuControl comb attachment
by grasping the flexible top portion. Always pull off
by the bottom part of attachment.
Q Switch the Groomer ON.
□ Make well-controlled movements.Touch the
hair/skin lightly with the Groomer.
Defining Beard, Moustache and
Sideburns
D Be certain the Groomer is in the OFF
position.
Q Remove the AccuControl comb attachment
by pressing and sliding the Hair Length
Selector upwards (fig. 7).
B Detach the full width trimmer attachment by
pushing the release button (fig. 8).
□ Put the precision trimmer attachment on the
Groomer (fig. 9).You will hear a click.
I Hold the Groomer upright when you use the
precision trimmer attachment (fig. 10).