Put it to the test, To charge/recharge, Corded hair clipping – Philips QC5345-15 User Manual
Page 4: Cordless hair clipping
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Put It To The Test
Like many new products, your Philips Norelco
Power Hair Clipper may take a little getting used
to. If you are using an electric Clipper for the first
time, or if you've been using a different brand, take
the time to acquaint yourself with your new Hair
Clipper.
Your Hair Clipper features an extra strong motor
and stainless steel cutter blades to comfortably clip
even the toughest hair.
Throw your scissors away and put your new
Hair Clipper to the test. We guarantee precise,
professional
results
or
Philips
Norelco
will
refund you the full purchase price as long as the
request is received within 45 days of purchase.
To Charge/Recharge
I Fully charge Clipper before using for the first
time or after non-use for a long period of time.
> Charging, recharging, or using Clipper at
temperatures below 40°F or higher than 95^
adversely affects lifespan of the battery.
Do not charge/recharge or use Clipper corded
until fully dry.
D
Be certain Clipper is OFF.
□
Insert the appliance plug directly into
the Clipper and plug the adapter into any
120V AC outlet (fig 1). Use only the cord
provided.
H The Charging Light on the appliance will
blink green to indicate the Clipper is
charging (fig. 2).
> It will take approximately 1 hour to fully
charge the Clipper for a cordless clipping
time of up to 75 minutes.
□ When the battery is fully charged, the
Charging Light lights up green continuously.
NOTE: After 30 minutes the Charging Li^ht
goes out.
H Disconnect the cord and unplug from
electrical outlet.
Corded Hair Clipping
I Only use the Clipper corded when the battery
is empty.
> Clipper does not recharge during corded
clipping.
n Connect cord provided to clipper and plug
clipper into electrical outlet (fig. 1).
B If battery is completely empty, wait a few
minutes before switching clipper ON.
B Slide ON/OFF switch ON to begin clipping.
□ Turn clipper OFF and unplug.
Cordless Hair Clipping
D Charge according to directions. Unplug
Clipper from outlet and remove cord.
B
Slide ON/OFF switch ON to begin clipping.
B
If the charge runs low while clipping, the
green Charging Light will blink orange.
□ If the charge runs out while clipping, connect
cord provided to Clipper and outlet. Wait
a few seconds and then turn Clipper ON to
continue clipping.