Philips QC5345-15 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assistance
For assistance, visit our website:
or call toll free: 1-800-243-3050
Information is available 24 hours a day,
7 days a week.
Storage
I Be sure Clipper is turned OFF. Remove cord
from outlet and Clipper before storing in a
safe, dry location where it will not be crushed,
banged, or subject to damage.
I Do not wrap cord around Clipper when
storing.
I Store cord in a safe location where it will not
be cut or damaged.
I Do not place or store Clipper where
it can fall or be pulled into a tub or sink, water
or other liquid while plugged in.
Battery Removal
I
This Philips Norelco Clipper contains a
rechargeable Lithium-Ion battery
which must be disposed of properly (fig. 13).
I Battery should only be removed when
Clipper is to be discarded.
► For assistance, visit our website:
or
call toll free: 1-800-243-3050
D Unplug electrical cord from outlet and
Clipper before dismantling Clipper.
B Allow Clipper to run until the battery is
empty/depleted.
H Turn Clipper OFF.
□
Remove any comb and clipping attachment
from the handle.
B Check if there are any screws in the back or
front of the appliance. If so, remove them.
□
Remove the back and/or front panel of the
appliance with a screwdriver. If necessary,
also remove additional screws and/or parts
until you see the printed circuit board with
the rechargeable batteries.
B IF necessary, cut the wires to separate the
printed circuit board and the rechargeable
batteries from the appliance.
□
Do not attempt to replace battery. Insulate
battery ends by covering with tape and/or
place battery in a small plastic bag.
B Discard your Clipper. Do not attempt to
plug electrical cord into the outlet or
recharge the Clipper after the battery has
been removed.
EE
Contact your local town or city officials
for battery disposal information or call
for
battery drop-off locations.