Assembly, Step 3, Step 4 – Coleman 5040-761 User Manual

Page 5: Step 5

Advertising
background image

5

Assembly

continued.

Step 3

(continued)

Step 4

(continued)

Step 4

■

Set cylinder cover assembly on

top of heater base. Position opening
opposite the wheels.

■

Tighten all fasteners. Use a #2

Phillips screwdriver to tighten all
screws. Use a 7/16" open end
wrench to tighten all hex nuts.

Step 5

■

Attach three Support Brackets to Base with three large screws down-

ward through Support Brackets into the Base.

■

Attach one large screw loosely

at base of the second Side
Support Bracket.

■

Attach the second Side Support

Bracket loosely with Hex Nut at
top.

1 Required

Large Screw

2 Required

Large Screw

3 Required

Large Screw

1 Req’d

Hex Nut

■

Attach Cylinder Cover Pieces to Base with two large screws horizon-

tally into the Base Tabs.

Advertising
This manual is related to the following products: