Coleman 5040-761 - Manual (Page 7)

7
Assembly
continued.
■ Insert head assembly into post.
■ Control knob should be above
decal on post.
■ Attach head assembly to post,
and loosely install three screws.
■ Tighten screws securely.
3 Required
Small Screw
Step 14
■ Support Heater.
■ Locate assembled reflector
on 3 studs (ref. Step 12).
■ Install washers on studs &
securely tighten acorn nuts but
do not overtighten! Use a
7/16" nut driver or open-end
wrench.
Step 13
■ Load head assembly by inserting hose into post.
Step 12
■ Insert studs into screen cover.
■ Remove protective film from all reflector pieces prior to assembly.
■ Assemble Reflector Assembly
9 Req’d
Acorn Nut
3 Req’d Brass Reflector Studs
Step 15
3 Req’d
Edge Pins
9 Req’d
Washers
3 Req’d
Flat Head Screw
3 Req’d
Acorn Nut
3 Req’d
Washers
■ Install edge pins into the lower
lip of the reflector panel.
Edge Pin
■ Place the other end of the Edge
Pin into a second panel of the
reflector. Place upper hole in sec-
ond piece over upper stud.
Upper Stud
■ Install the Flat Head Screw into
the hole from the bottom of the first
two reflector panels.
■ After repeating the above steps
to assemble the third reflector
panel, set the top cap in place and
secure with washers and acorn
nuts. Make sure all nuts are snug,
but DO NOT OVERTIGHTEN.
■ Loosely install the Flat Head
Screw in place with a washer and
Acorn Nut.
1 2
3 4
5