Curtis RCD544 - Manual (Page 7)

Insert two(2) “AAA”/1.5V batteries following the polarity as indicated in the compartment to the right.
Alkaline batteries are recommended for long using time.
Note: when planning not to use the remote control for a long time. Remove the batteries in order to avoid
the electrolyte leakage.
UNIT POWER SUPPLY ( mains 120V/60Hz)
Connect the power cable plug to the (120V/60Hz) wall outlet.
Warning:
Before using the unit. Check that the local mains supply is compatible with the HI-FI System (120V 60Hz)
Do not plug or unplug the power cable when your hands wet.
When planning not to use this unit for long periods of time(i.e, Vacation etc.) disconnect the plug from the
wall outlet.
When disconnecting the power cord from the wall outlet , grasp the plug; do not pull the cord in order to
avoid shock risks caused by the damaged cable.
HEADPHONE JACK
This unit will accept stereo headphones with a Ф 3.5mm plug. Before connecting the headphones set
the volume to minimum level as not to damage your ears or the headphones. Connect the headphones to the
headphones jack. The speakers will be automatically disconnected.
Warning: Prolonged exposure to high sound levels may permanently damage your hearing. You may
not hear some warning sound while wearing these headphones.
VOLUME
Press VOL- or VOL+ to adjust the volume to the desired level.
VOL- : to decrease the volume;
VOL+: to increase the volume.
LISTENING TO THE RADIO
1. Press CD/RADIO FUNCTION SWITCH up to RADIO position.
2. Press STANDBY/ON button to turn on the unit.
3. Press the Band (AM/FM) Button to select AM or FM.
4. Turn TUNING Knob to tune in desired Radio station.
5.
To turn off Radio, Press STANDBY/On Button to turn off the unit.
Note: While in the Radio Mode, the display will indicate as Frequency.
ANTENNAS
An AM antenna is built outside the unit.
For better reception , FM wire antenna shall be fully untied and adjusted well
CLOCK SETTING
In power off (standby) mode:
Press and hold Time button to set the clock
7