Selecting a different track, Finding a passage within a track, Different play modes: shuffle and repeat – Philips MC-320-37 User Manual
Page 15: Programming track numbers, Erasing the program, Reviewing the programme, Cd operation, Reviewing the program
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CD Operation
Selecting a different track
Press l< or >1 once or repeatedly until the
desired track number appears in the display.
If you have selected a track number shortly after
loading a disc or in the PAUSE position, you will
need to press > II to start playback.
Finding a passage within a track
Press and hold down on « or »
The disc is played at high speed and low
volume.
When you recognise the passage you want,
release « or ».
Normal playback continues.
Note:
- During a disc programme or if SHUFFLE/
REPEAT active, searching is only possible within the
same track.
Different play modes: SHUFFLE
and REPEAT
You can select and change the various play
modes before or during playback.The play
modes can also be combined with PROGRAM.
SHUFFLE..........tracks of the entire disc are
played in random order
SHUFFLE and REPEAT ALI___ to repeat the
entire disc continuously in
random order
REPEAT ALL ... repeats the entire disc/ program
REPEAT............plays the current track
continuously
To select your play mode, press the SHUFFLE
or REPEAT on the remote control before or
during playback until the display shows the
desired function. (5HUF. REPEAT, REPEAT ALL)
Press > II to start playback if in the STOP
position.
If you have selected SHUFFLE, playback starts
automatically.
To return to normal playback, press the
respective SHUFFLE or REPEAT button until
the various SHUFFLE / REPEAT modes are no
longer displayed.
Programming track numbers
Program in the STOP position to select and
store your disc tracks in the desired sequence. If
you like, store any track more than once. Up to
40 tracks can be stored in the memory.
Press PROG / REV (or PROGRAM / REV on
remote control) to enter the programming
mode.
A track number is shown and
program
flashes.
Use the l< or > I to select your desired track
number.
Press PROG / REV (or PROGRAM / REV on
remote control) to confirm the track number to
be stored.
The number of tracks programmed is shown.
Repeat steps
2-3
to select and store all desired
tracks.
-> r'lEf'inRy
program more than 40 tracks.
rULL is displayed if you attempt to
To start playback of your disc program,
d
''
css
STOP H I ver "y > II O'" rii'css > II dii'ccfV-
Reviewing the program
In STOP mode, press and hold PROG / REV.
Until the display shows all your stored track
number in sequence.
Erasing the program
You can erase the program by;
pressing STOP ■ twice during playback;
opening the CD compartment;
PROGRAM
disappears from the display.
You can also press STOP I
mode.
I to cancel your play
15