Philips MX2790B - Manual (Page 27)

R emote
C on troi . O peration ( c ontint ed )
A d d r i s s ( ’ o i ) i : l ’ k o ( ; u \ \ i m i \ ( . o i
K i M o i i ;
For m ost hom es this step would
not be needed but for your
inform ation:
U p to 9 different rem ote locator
address codes can be set on w hich the
TV can send out its "hom ing” signal.
This is done in case there is m ore than
one TV (w ith a rem ote locator)
present, and you w ant only one
specific rem ote to be signaled when the
TV is turned O N.*
To set a Locator Address C ode:
With TV turned ON, press the
LOCATOR CODE button on the
remote. (Also be sure the TV
SYSTEM button on the remote has
been pressed.)
You will need a pencil or pen to press
the recessed button.
The TV shows the present Remote
Locator Code.
Press any number button (0-9) on
the remote to set or change the
Locator Code.
See the above infonnation on
how to use the Locator Code
Button for Programming.
S m V R I M i l l *
Remember, if batteries are
g replaced the Locator Code
will need to be reentered.
When setting the Locator Code if any
button, other than the number buttons,
are pressed the remote will return to
its normal operation mode.
*For owners who live in an apartment
(townhouse or condominium)
complex, this task may be necessary
since the remote locator's signal can
be sent and detected directly through
adjoining walls.
27