Operating the system, Demonstration mode, Easy set – Philips FW555C37 User Manual
Page 14: Switching the system on, Switching the system to standby mode, Selecting the source
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING THE SYSTEM
Important:
Before you operate the system,
complete the preparation procedures.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the
system.
When the system is switched
on for the first time, the demonstration
mode will start automatically.
Notes:
- During the demonstration, if you press
any source (or standby-on) button, the
system will switch to the respective
mode (or standby).
- When the system is switched to standby
mode, the demonstration will resume
five seconds later.
To stop the demonstration mode
• Press and hold
STOP*CLEAR ■ (on
the system only) for
five seconds
when
the system is in demonstration mode.
-* The demonstration will stop.
"DEriO OFF"“ is displayed.
The system will switch to standby
mode.
-* (for FW555C only)
About 5 seconds later, the system
will go into an energy saving mode
(< 2 watts). The low power
STANDBY ON LED will be lit.
Note:
- Even though the AC power cord is
removed from and reconnected to the
wall socket, the demonstration will
remain off until it is switched on again.
To start the demonstration mode
• Press and hold
STOP*CLEAR ■ (on
the system only) for
five seconds
when
the system is in standby mode.
The demonstration will begin.
Easy Set
EASY SET allows you to store all available
radio stations automatically.
1 Press and hold STANDBY ON (on the
system only) (or
five seconds:
when
the system is in standby or
demonstration mode.
-* "EfiSY SET" will be displayed,
and followed by "TUNER" and then
"flUTU".
EASY SET will start searching for all
radio on EM band and then followed
by radio stations on AM band.
— All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
- EASY SET will start with the EM band, if
there are still presets available, the
system will continue to store the AM
band.
- When EASY SET is used, all previously
stored radio stations will be replaced.
- The last preset radio station will appear
on the display when EASY SET is
completed.
Switching the system ON
• Press
STANDBY ON (on the system
only),
CD, TUNER, TAPE or AUX
You can also switch on the system by
pressing any one of the CD DIRECT PLAY
buttons.
Switching the system to
standby mode
• Press
STANDBY ON again or (|) on the
remote control.
The system will switch to standby
mode.
(for FW555C only)
About 5 seconds later, the system
will go into an energy saving mode
(< 2 watts). The low power
STANDBY ON LED will be lit.
Selecting the Source
• Press the respective source selection
button:
CD, TUNER, TAPE or AUX
The display indicates the selected
source.
Note:
- For an external source, make sure you
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the AUX
IN terminals.
14