Contouring without a comb attachment, Shaving – Philips QC5550-40 User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Contouring without a comb

attachment

I

Use the Clipper without a comb attachment to

clip very close to the skin (3/64 in/1mm).

I Be careful when you are clipping without a

comb as when the Clipper is turned on it will

remove every hair it touches.

n Remove the comb by pulling it off the swivel

head (fig. 12).

Never pull at the flexible top of the comb. Always

pull at the bottom part.

a

To contour the hairline around the ears,

comb the hair ends over the ears.

Q Press the ON/OFF Button to turn on the

appliance.

Q Tilt the Clipper in such a way that only one

edge of the cuttiing element touches the hair
ends. Only cut the hair ends.The hairline
should be close to the ear (fig. 13).

B To contour the neckline and the sideburns,

turn the Clipper and make downward

strokes (fig. 14).

NOTE: Move the Clipper slowly and smoothly.

Simply follow the natural haii'line,

Q Adjust the position of the swivel head to

make contouring easier.

Shaving

TIP: Shaving is easier when the hairs are shorter

than 1mm. If the hairs are longer t/ion 1mm, use
the cutting element without the comb to pre-cut
hairs to the shortest setting.

D

Turn off Clipper.

u

Pull the comb off the swivel head (fig. 12).

B

Press the release buttons (1) and remove

the cutting unit from the handle (2) (fig. 15).

□ Attach the shaving head by pressing it onto

the appliance. You will hear a ‘click’ (fig. 16).

Make sure that the shaving head locks into

position properly.

B

Remove the protection cap from the shaving

head (fig. 17).

If the shaving head foil shows signs of wear or

damage, do not use as injury may occur Do not
use the shaving head until foil has been replaced.

B Adjust the position of the swivel head to

make shaving easier.You can do this before

and/or during use (fig. 18).

Q Place the shaving head on your scalp and

start shaving (fig. 19).

NOTE: Make sure that the shaving foil is always in

full contact with vour scalp.

TIP: To see the results clearly, look into the mirror

supplied, with your back turned towards a second
mirror.

Advertising
This manual is related to the following products: