Perfect Aire PAHP12002 - Manual (Page 10)

9
Note:
FIG. 2
FIG. 1
Remove and dispose of/recycle packaging materials. Remove tape and glue residue from surfaces before
installing the air conditioner. Rub a small amount of liquid soap over the adhesive with your fingers. Wipe
with warm water and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue.
These products can damage the surface of your air conditioner.
Handle the air conditioner gently.
1. Remove the air conditioner from the carton and place it on cardboard.
2. Remove 1 shipping screw from each side of the cabinet (FIG 3).
3. Remove front panel by removing 1 Phillips screw from each side of the front panel. Set screws aside and
save (FIG. 4).
4. Pull on the handles to slide the air conditioner out of the cabinet. Place the air conditioner on cardboard
(FIG. 5).
Installation parts are supplied for double-hung windows up to 36″ (91.4 cm) wide. A special Wide Window Kit
is available from your dealer or service center. See “Accessories.”
Do not use any screws other than those specified here.
Do not use an extension cord.
Cabinet louvers must not be obstructed. Air must be able to pass freely through the cabinet louvers.
(Fig.1)
Grounded electrical outlet within 4 ft (122 cm) of where the power cord exits the air conditioner.
Free movement of air in room to be cooled.
A large enough opening for the air conditioner.
Adequate wall support for weight of air conditioner. Air conditioner weighs between 70 and 85 lbs (32 to 40 kgs).
Window Installation:
Window opening measurements (FIG. 2):
26-7/8″ to 36″ (68.3 cm to 91.4 cm) opening width.
16-1/2″ (41.9 cm) minimum opening height.
Remove packaging material:
A. Cabinet louvers
INSTALLATION INSTRUCTIONS
Location Requirements:
IMPORTANT: Observe all governing codes and ordinances. Check the location where air conditioner will be
installed. Proper installation is your responsiblity. Make sure you have everything necessary for correct installation.