phil&teds verve pre-2014 - Manual (Page 5)

VERVE
Product Care / Conseils d’entretien / Produktpflege / Cuidado del producto / Productverzorging
IMPORTANT IMPORTANT
• Always load/unload your children on level ground.
• Ensure the brake is engaged during the loading
and unloading of children.
• Care should be taken if the stroller is used on
stairs or escalators.
• Always use the safety strap.
• Excessive wear can reduce effectiveness and
safety. Parts may need lubrication. Inspect
essential components for:
Fraying - especially webbing straps and safety
harness.
Wear - locks, snap fasteners, tyres, plastic and
moving parts.
Safety - locks must not be loose.
Tyres & Tubes
• The valve is car-size. Manually inflate to 20 –
22psi max. releasing air gives a softer ride but
lower pressure reduces tread life.
• New inner tubes and tyres are generally
available (21/4” x 121/2” tyre) from your dealer,
cycle or specialist wheel shops. Standard tyre
kits can repair punctures.
• A flat tyre can result from grit holding the valve
open; to check: inflate tyre, deflate rapidly, and
re-inflate.
• Tyres and tubes are not under warranty. Do not
over inflate. Tyre pressure is affected by heat
especially when inside parked cars.
• Rubber tyres can react with some surfaces
(including, but not limited to, vinyl floor
coverings, carpets, synthetic laminates,
parquet and linoleum) and cause stains.
Always stand the stroller on a protective
surface when indoors.
For rights & remedies, refer www.philandteds.com/warranty