Sport instructions, Inline, Buggy – phil&teds sport v2 User Manual
Page 7: Bits ` bobs, Safe ` sound, Wheeling ` dealing, Gettin’ it together
inline
TM
buggy
sport instructions
assembling your new phil`teds inline
TM
sport
is effortless and fun. just follow these simple
steps and in 5 minutes you’ll be off!
bits ` bobs
red numbers below refer to buggy parts
indicated above.
1.
rear guards
2.
rear wheels
3.
sun hood
4.
front wheel
5.
rear axles
6.
handle
7.
back flap
8.
footwell
9.
swivel lock
10.
harness
11.
fold lock
12.
auto frame lock
13.
pull bar
14.
wrist strap
15.
double kit (sold separately)
16.
retaining strap (comes with double kit)
safe ` sound
we’ve attained the following safety standards:
•
EN 1888:2005
•
AS/NZS 2088:2000
•
ASTM F833-07a
wheeling ` dealing
keep tyres inflated to 22PSI
a
release fold lock by pushing in grey button.
b
attach rear guards using a screw driver
as shown. screws are located in rear guard
housing on buggy frame.
c
to attach rear wheels: first insert axles in
rear wheels (from side without brake disk).
then depress
silver axle hub and insert into
buggy axle housing.
d
lift footwell as far as hinge will allow.
e
to attach front wheel: fully extend swivel
lock and insert wheel rod into buggy frame,
as shown. release swivel lock and check
wheel is in place for use.
to lock/unlock swivel wheel: extend and
rotate swivel lock, aligning silver pin with
hole in underside of swivel lock knob.
turn wheel towards rear of buggy (parallel
with rear wheels). lock will click into place.
to swivel, extend black swivel lock out and
rotate until knob rests on silver pin instead
of being inserted into hole.
gettin’ it together
f
turn buggy over onto 3 wheels. pull handle
up until you hear a resounding ‘click’.
ensure that auto frame locks are engaged.
note
for double buggy do not lift frame using
double seat, as you may damage hinges.
2