phil&teds sport v2 - Manual (Page 9)

inline
TM
buggy
note hinges are marked with L and R
denoting left and right when viewed from
behind buggy.
t feed retaining strap beneath rear of hood,
loop it around handle and connect clip.
warning: never use baby & toddler buggy
without using retaining strap.
double buggy
u start with buggy seat in upright position.
remove hinges from double seat. align
tubes with supports on back of buggy frame.
push in nib springs and slide on ensuring nib
springs pop through holes on double kit
frame. load heavier toddler in front seat first.
then place lighter toddler in double seat at
back. always unload rear toddler first.
warning: never place child in double seat
without a child in front seat.
v double kit has a lay-back setting.
to recline: unzip side zips and push top
of seat under bar as shown.
folding
remove double kit if attached in rear position.
w rotate both auto frame locks at bottom of
frame seat down 180 o and press in, allowing
frame to collapse.
x lift up cross bar allowing front wheel to fold
under frame. press frame flat until fold lock
clicks into place.
note by removing front wheel buggy will
fold smaller.
add ` adapt
other products available for the sport:
buggy covers
•
single and double storm covers
• single and double sun mesh covers
buggy beds and liners
•
cocoon • lamb skin liner
• race seat liner • sponge ted liner
• buggy bunny liner
• snuggle & snooze sleeping bag
buggy storage
•
pannier bags • hang bag
• travel bag • shop & drop
4