phil&teds cocoon genius User Manual
Page 19
Advertising
Installation in the vehicle /18
• Open the Belt Clamp Handle, insert the
diagonal belt into the clamp slot (5-E).
• Check: Use only one of the belt clamps,
it is located at the same side as the car
retractor.
• Remove all the slack in the belt, then close
the clamp (5-F). Turn the Tensioner Handle
on (5-G).
• Place your child into the seat (5-H) and fit
the harness (see 4.1).
• Tighten the harness securely by pulling the
adjuster strap (5-I).
• Check: Any straps holding the restraint to
the vehicle should be tight, that any straps
restraining the child should be adjusted to
the child's body, and that straps should not
be twisted.
Advertising