phil&teds cocoon genius - Manual (Page 21)

Installation in the vehicle /20
• Remove all the slack in the belt and close
the clamp (5-N/5-O).
Check: Use only one of the belt clamps,
it is located at the same side as the car
retractor.
• Turn and lock the Tensioner Handle (5-P).
• Place your child into the seat (5-Q) and fit
the harness.
• Tighten the harness securely by pulling the
adjuster strap (5-R).
• Check: Any straps holding the restraint to
the vehicle should be tight, that any straps
restraining the child should be adjusted to
the child's body, and that straps should
not be twisted.