Potter PFC-9000 Series - Manual (Page 48)

48
PFC-9000 • 5403535 • REV G • 9/08
Bypass
Item 2 in the Command Menu is the Bypass Menu, which allows the user to bypass a single device, circuit, loop or disconnect the
common relays. When the Bypass Menu is activated the screen will require the user to select the area to bypass.
- SELECT DEVICE -
LOOP: 0
Similarly, the address that is desired to be bypassed is selected using the arrow keys. (Each digit must be selected using the left
and right arrows.)
- Select Device -
Loop: 0
Device: 001
Signal Output
L0 001not bypassed
Bypass? Y
Push the ENTER key after selecting the device and then the confirmation. That address is then bypassed. The yellow
trouble LED will be illuminated and pushing the will display the device/circuit that is bypassed. Follow the
same procedure for unbypassing the device/circuit. In addition, the loop and relay disconnect are operated using the same
procedure as outlined above.
INFO
-BYPASS MENU-
1 Device/Circuit
2 Loop
3 Relay Disc
Selecting number 1 or the Device/Circuit portion, the user may have to enter a password if the Bypass Menu is pass code
protected. The user will then have to select which loop the device is on that will be bypassed. The loop is selected using the arrow
keys until the desired loop is displayed.