Potter EVD-2 User Manual
Page 10
10
EVD-2 • 5401042 • REV N • 6/09
Recommended Control Panel Wiring and Remote Test and Annunciator Connections
Figure 5a.
Installation
The EVD-2 System must be installed in accordance with all applicable local codes.
1.
Mount EVD-M controller and any EVD-R remote pickups and wire according to Figures 4 and 5a. Remove end of line resistors from the
EVD-M and all EVD-R's except the last EVD-R in the remote pickup network. If no remote pickups are installed do not remove the end of
line resistors on the EVD-M.
2.
Refer to Figure 5a for connection of a remote test annunciator, RTA, and/or a UL listed central station test unit, if applicable.
3.
Refer to Figure 4 for the connection of UL listed dry contacts, if applicable.
4.
Verify proper installation of the end of line resistors. Refer to Figures 2b and 4 for systems with remote pickups.
5.
Wire control unit connections and apply 12 VDC to the EVD-2 system. Refer to Figure 5a.
6.
See Figure 5b & 5c for 4 or 6 wire installation wiring.
7. High Security "B" cable and connectors to 24 hr alarm zone as shown are UL requirements for UL safe complete installation.