Pro Boat PRB07000 - Manual (Page 10)

10
EN
Ragazza
When You are finished
1. Power off the switch harness.
2. Disconnect the battery.
3. Power off the transmitter.
4. Remove the battery from the boat.
5. Loosen all lines.
Always store the boat open (without the hatch sealed) or
moisture may allow mold and mildew to grow in the boat.
Checklists
Before Boating
• Install fully charged batteries in your boat and
transmitter
• Make sure the boat is bound to the transmitter
(otherwise, bind the boat to the transmitter using
the included binding instructions)
• Make sure all linkages move freely on the boat
• Perform a Control Direction Test with the transmitter
• Adjust the steering rate on your transmitter as desired
• Find a safe and open area of operation
• Plan a safe route for the water and wind conditions
After Boating
• Always power off the receiver before powering off
the transmitter to maintain control of the boat and
to retain transmitter binding
• Disconnect the battery from the receiver and remove
the batteries from the boat
• Fully dry the inside and outside of the boat. Remove
the hatch before storing your boat.
• Repair any damage or wear to the boat
• Make note of lessons learned from the trimming of
your boat, including water and wind conditions
NOTICE: Running the boat in salt water could cause
some parts to corrode. If you run the boat in salt water,
rinse it thoroughly in fresh water after each use.
NOTICE: Because of its corrosive effects, running RC
boats in saltwater is at the discretion of the modeler.
NOTICE: When you are finished boating, never leave
the boat in direct sunlight or in a hot, enclosed area
such as a car. Doing so can damage the boat.
Maintenance and Repair
When parts are not repairable, see the Replacement
Parts List for ordering by item number. For a listing of all
replacement and optional parts, refer to the list at the end
of this manual.
Apply a drop or two of thin CA (cyanoacrylate adhesive)
to each of the knots on the line to prevent the knots from
coming loose.
1 2
3
4
CA