Pro Boat PRB07000 - Manual (Page 5)

5
EN
Ragazza
failsafe
In the unlikely event that the radio link is lost during use,
the receiver will drive the servos to their pre-programmed
failsafe positions (normally sails out and straight steering).
If the receiver is powered on before powering
on the transmitter, the receiver will enter failsafe mode,
driving the servos to their preset failsafe positions. When
the transmitter is powered on, normal control is resumed.
Failsafe servo positions are set during binding.
Boat Assembly
1. Remove the hatch from the hull. Insert the keel post
in the bottom of the hull as shown. Secure the post
inside the hull by using a washer and lock nut.
2. Install the weight on the keel with the wide end of the
weight facing the front of the boat by using a washer
and lock nut.
3. Install a plastic spacer on the rudder post. Install the
rudder post in the bottom of the hull. Secure the
rudder arm on the top of the post by using the hex
head screw and a 2.5mm hex wrench.
Tip: Apply a thin coat of marine grease (PRB0101 or
PRB0100) to the rudder post.
4. Install the battery holder in the hull socket. Replace
the hatch.
Tip: We recommend applying tape (PRB0102, sold
separately) over the hatch and hull to keep out water.