Pro Boat PRB2350 - Manual (Page 6)

6
Receiver Batteries
 1. Use a 2.5mm hex wrench to remove the
eight 2.5mm hex head screws that secure
the radio box cover.
 2. Remove the battery holder and install 4
AA alkaline batteries in the polarity shown
on the battery box.
Note: You may consider
upgrading the receiver battery
to a rechargeable battery
pack. We recommend a
6-volt 1400mAh 3+2 hump
rechargeable battery pack or
equivalent (DYN1445). See
your local Pro Boat dealer.
Transmitter Batteries
 1. Remove the transmitter from the box.
 2. Remove the battery cover on the
bottom of the transmitter.
 3. Insert 4 AA alkaline batteries into the
battery holder.
Note the proper polarity of
the batteries.
 4. Turn on the transmitter and confirm
that the LCD illuminates, indicating proper
installation of fully charged batteries.
 5. Turn on the receiver switch and move
the controls. Confirm that all controls
operate in the proper direction and are
controlled by the proper transmitter input.
 6. Turn the transmitter and the receiver
switch off. To keep the boat from receiving
stray signals, the transmitter should be
turned on first, followed by the receiver.
Likewise, the receiver should be turned off
first, then the transmitter.
 3. Wrap the battery pack in foam and
reinstall the radio box cover.
Section 3: Installing the Radio System Batteries