Pro Boat PRB2750 - Manual (Page 5)

5
Section 1: Building the Boat Stand
 1. There are 4 plywood pieces. The 2 short
plywood pieces are the ends of the boat stand.
 2. Attach the 2 long plywood pieces of the
interlocking boat stand to one end of the short
plywood pieces. Repeat with the remaining short
plywood pieces.
 3. Secure the interlocking boat stand with thick
CA or Epoxy.
Parts Needed
Rudder and 2.5mm hex screw
 1. Locate the stainless steel rudder and 2.5mm
hex screw.
 2. Carefully insert the rudder as shown.
 3. Find the flat spot on the rudder. Using a
2.5mm hex wrench, tighten the hex screw on
the flat spot as shown.
Section 2: Rudder Installation