Pro Boat PRB3050S - Manual (Page 6)

6
 1. Make sure that the radio is on and the battery
is plugged into the speed controller and
motor.
 2. Carefully place the boat in the water. Pilot
the boat at slow speeds, staying close to
the shoreline to ensure that you have good
control and that the boat is functioning
correctly.
 3. If the motor operates when the throttle
is released, it may be necessary to adjust
the trim on the transmitter so the motor is
stopped when the throttle is released.
 4. Be certain to avoid all objects in the water.
Once you feel comfortable with the control
of the boat, it is safe to go further from the
shore and at faster speeds.
 5. If the boat is losing speed, steer the boat
carefully back to shore. It will be necessary
to replace or recharge the battery before
running your boat again.
 6. If the boat tends to drift one direction
during operation, adjust the steering trim to
compensate.
Lake water is forced into the cooling system
when the boat is moving forward via a water
pick-up mounted on the bottom of the hull and is
exhausted through a port on the side of the boat.
If no cooling water is exhausting the port, stop
operation and remove debris from the system or
repair any breaks in the system.
Operating the Volere 22 without proper water
cooling will damage the motor.
Water
Outlet
Water
Inlet
Throttle
Trim
Steering
Trim
Testing the Boat in the Water
Water Cooling