Pro Boat PRB3600 - Manual (Page 11)

11
Slide the navigation light into the forward
hatch, guiding the wires through the holes
in the cabin. Use medium CA to secure
the navigation light to the front hatch.
Carefully solder the wires together to
power the navigation light, making sure
to connect the red wire to the red wire
and the black wire to black wire. The
electrical connection to power the light
is made at the front magnets when the
hatch is mounted to the hull.
Use heat-shrink tubing or electrical tape
to insulate the connection made in the
previous step.
The switch to turn the accessory lighting
on is located on the left side of the
hull near the motor. The lighting will
only power on when the batteries are
connected to the speed controller. With
the batteries plugged in, turn on the
lighting and place the forward hatch in
place. Sit back and enjoy the glow from
the scale lighting of your PT-109.
Accessory Installation