Pro Boat PRB3600 - Manual (Page 10)

10
Lower the threaded stud into the
pre-drilled holes in the top of the hull.
Slide the tubing onto the stud from the
inside of the hull. Repeat this step for
all four torpedos.
Slide the front of the torpedos so they
are aligned with the hull. Once all the
torpedos are in position, replace the rear
cover and use a #1 Phillips screwdriver to
attach the cover.
Slide the rear mast into the tube at the
rear of the hull.
Slide the scale antenna into position on
the side of the driver's cabin.
Slide the spotlight into position in the
tube next to the driver's seat.
Accessory Installation