PS Engineering PMA7000CAP Installation Manual - Manual (Page 26)

PS Engineering
PMA7000M-S Series Audio Selector Panel and Intercom System
Installation and Operator’s Manual for Civil Air Patrol
200-072-0004 Page 4-1 Rev. 4, Sept. 2000
Section IV- Warranty and Service
4.1 Warranty
In order for the factory warranty to be valid, the installations in a certified aircraft must be
accomplished by an FAA- certified avionics shop and authorized PS Engineering dealer. An
FAA Form 337 must also be accompanied by the warranty card for this warranty to be in
effect. If the unit is being installed by in an experimental aircraft, a factory- or dealer made
harness must be installed for the warranty to be valid.
PS Engineering, Inc. warrants this product to be free from defect in material and workmanship
for a period of one year from the date of installation. During this one-year warranty period, PS
Engineering, Inc., at its option, will send a replacement unit at our expense if the unit should be
determined to be defective after consultation with a factory technician. Shipping charges to
return the defective unit are the responsibility of the customer.
This warranty is not transferable. Any implied warranties expire at the expiration date of this
warranty. PS Engineering SHALL NOT BE LIABLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES. This warranty does not cover a defect that has resulted
from improper or unreasonable use or maintenance as determined by us. This warranty is void if
there is any attempt to dissemble this product without factory authorization. This warranty gives
you specific legal rights, and you may also have other rights which may vary from state to state.
Some states do not allow the exclusion of limitation of incidental or consequential damages, so
the above limitation or exclusions may not apply to you.
4.2 Factory Service
The unit is covered by a one-year limited warranty. See warranty information. Call PS
Engineering, Inc. at (865) 998-9900 before you return the unit. This will allow the service
technician to provide any other suggestions for identifying the problem and recommend possible
solutions.
After discussing the problem with the technician and you obtain a Return Authorization Number,
ship product to:
PS Engineering, Inc.
Attn: Service Department
9900 Martel Rd
Lenoir City, TN 37772
Phone (865) 988-9800
FAX (865) 988-6619
Please include a detailed description of the problem and a telephone or fax number where we
can contact you during business hours.