PS Engineering PMA8000SR Pilot’s Guide - Manual (Page 10)

Page 10 202-880-0000 PMA8000-SR Pilot Guide R5
Remote Control
Primary operation of the SIRIUS satellite radio module is through the
portable remote control, PN 051-880-0150. This device must be pointed
at the PMA8000-SR front panel to
control the satellite function.
[Replacement Battery CR2025]
The Remote has the following func-
tions:
ο
ON/OFF, SIRIUS Mode Module
on/off (does NOT affect audio
panel/intercom/marker beacon op-
eration)
ο
0 – 9, Direct channel selection
ο
VOL DN/VOL UP, Volume control
ο
MUTE, SIRIUS Radio mute
ο
NEXT CH/LAST CH, Next/last
channel
ο
NEXT CAT/LAST CAT, Next/last
category
ο
SET (0–6) Channel store and recall
for favorite channels
ο
Q “Query” button to playback chan-
nel in use
ο
SCAN, Scan button to sample channels
ο
LAST CH, jumps back to the previously used channel
To turn the Satellite Radio on, press the On/Off button. A voice will announce
“power on”. The satellite radio will begin to play on the last used channel. To
turn the SIRIUS radio off, press the button again.
To change the channel, simply press the digits (0 through 9). As soon as the
first digit is pressed, the audio will beep indicating a button has been pressed. If
another digit is not pressed within two seconds, the SIRIUS will change to the
new channel, and announce “Channel, followed by the selected channel number.
The NEXT CH and PREV CH buttons move to the next higher (or lower)
channel number, and will say the channel number.
The NEXT CAT and PREV CAT buttons will change to the first channel in the
next higher (or lower) category, such as from Pop to Rock, Country, Hip-Hop,
NOTE: The Satellite Radio audio follows the same muting rules, and will be
muted for intercom and radio activity unless the Karaoke mode is enabled.