Section iv- warranty and service, Warranty, Factory service – PS Engineering PCD7100-P Installation Manual User Manual

Page 19

Advertising
background image

PS Engineering

PCD7100 Series Audio Selector Panel and Intercom System

Installation and Operator’s Manual

200-971-0006

Page 4-1

Rev. 8, Jan. 2015

Section IV- Warranty and Service

4.1

Warranty

In order for the factory warranty to be valid, the installations in a certified aircraft must be accomplished by
an FAA-certified avionics shop and authorized PS Engineering dealer. If the unit is being installed by a
non-certified individual in an experimental aircraft, a factory-made harness must be used for the warranty to
be valid.

PS Engineering, Inc. warrants this product to be free from defect in material and workmanship for a period
of one (1) year from the date of installation as recorded in aircraft logbook and/or on FAA Form 337. Dur-
ing the twelve (12) months, PS Engineering, Inc., at its option, will send a replacement unit at our expense
if the unit should be determined to be defective after consultation with a factory technician.

All transportation charges for returning the defective units are the responsibility of the purchaser. All do-
mestic transportation charges for returning the exchange or repaired unit to the purchaser will be borne by
PS Engineering, Inc. The risk of loss or damage to the product is borne by the party making the shipment,
unless the purchaser requests a specific method of shipment. In this case, the purchaser assumes the risk of
loss.

This warranty is not transferable. Any implied warranties expire at the expiration date of this warranty. PS
Engineering SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. This
warranty does not cover a defect that has resulted from improper handling, storage or preservation, or un-
reasonable use or maintenance as determined by us. This warranty is void if there is any attempt to dissem-
ble this product without factory authorization. This warranty gives you specific legal rights, and you may
also have other rights, which may vary from state to state. Some states do not allow the exclusion of limita-
tion of incidental or consequential damages, so the above limitation or exclusions may not apply to you.

All items repaired or replaced under this warranty are warranted for the remainder of the original warranty
period. PS Engineering, Inc. reserves the rights to make modifications or improvements to the product
without obligation to perform like modifications or improvements to previously manufactured products.

4.2

Factory Service

The unit is covered by a one-year limited warranty. See warranty information. Call PS Engineering, Inc. at
(865) 988-9800 before you return the unit. This will allow the service technician to provide any other sug-
gestions for identifying the problem and recommend possible solutions.

After discussing the problem with the technician and you obtain a Return Authorization Number, ship prod-
uct to:

PS Engineering, Inc.
Attn: Service Department
9800 Martel Rd
Lenoir City, TN 37772
(865) 988-9800

FAX (865) 988-6619

Email: [email protected]

NOTE: PS Engineering will not be responsible for any units shipped in the U. S. Mail.

Units received without either a Return Authorization or a contact telephone number will be refused
and returned to the sender.

Advertising
This manual is related to the following products: