PS Engineering PMA6000M-S - Manual (Page 24)

PS Engineering
PMA6000 Series Audio Selector Panel and Intercom System
Installation Manual
200-066-0006 Page 4-1 Rev. 6, March 2005
Section IV- Warranty and Service
4.1 Warranty
In order for the factory warranty to be valid, the installations in a certified aircraft must be accomplished by
an FAA- certified avionics shop and authorized PS Engineering dealer. An FAA Form 337 must also be
accompanied by the warranty card for this warranty to be in effect. If the unit is being installed by in an
experimental aircraft by the owner/builder, a factory-made harness must be installed for the warranty to be
valid.
PS Engineering, Inc. warrants this product to be free from defect in material and workmanship for a period
of one (1) year from the date of installation (on units shipped after Jan 1, 2003, with serial numbers starting
with “Y”). During this one-year warranty period, PS Engineering, Inc., at its option, will send a replace-
ment unit at our expense if the unit should be determined to be defective after consultation with a factory
technician.
This warranty is not transferable. Any implied warranties expire at the expiration date of this warranty. PS
Engineering SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. This
warranty does not cover a defect that has resulted from improper or unreasonable use or maintenance as
determined by us. This warranty is void if there is any attempt to dissemble this product without factory
authorization. This warranty gives you specific legal rights, and you may also have other rights which may
vary from state to state. Some states do not allow the exclusion of limitation of incidental or consequential
damages, so the above limitation or exclusions may not apply to you.
4.2 Factory Service
The unit is covered by a one-year limited warranty. See warranty information. Contact PS Engineering,
Inc. at (865) 988-9800, fax (865) 988-6619, or
www.ps-engineering.com/support.shtml before you return
the unit. This will allow the service technician to provide any other suggestions for identifying the problem
and recommend possible solutions.
After discussing the problem with the technician and you obtain a Return Authorization Number, ship
product to:
Service Department
PS Engineering, Inc.
9800 Martel Rd
Lenoir City, TN 37772
(865) 988-9800 FAX (865) 988-6619
Email:
[email protected]
Units that do not have either an RMA number, a complaint and/or a contact phone number reachable dur-
ing business hours, will be refused from the Certified Repair Facility.
PS Engineering will not be responsible for units that are shipped vial Mail or Parcel Post.