Quick Charge QPA12-127V/15A - Manual

1
QPA12-127V/15A, MULTI SERIES Battery Charger
INTRODUCTION:
The Series Multi charger is designed to charge 6 - 60 cells in series, at a 1 to 15 amp rate. The
charge rate is controlled by one infinite adjustable control knob. Other important features of this
charger are:
CURRENT LIMITING: The maximum output of this charger is 15 amps. It cannot be exceed
no matter where the rate control is set or how many batteries are on line. This eliminates fuse
and breaker blowing, and drifting from initial current set point.
ANTI ARC: This feature provides a slight delay to the turn on circuit, minimizing arcing at the
battery terminals. It also eliminates power in the clamps, reducing shock hazard. At least three
volts are need to turn the charger on
WARNING: Do not use this charger on motorcycle batteries, nicad batteries, AGM
batteries, or gel batteries. This charger has no voltage limit, charging these
batteries could cause an explosion resulting in bodily harm.
IMPORTANT: DO NOT USE THIS CHARGER UNTIL YOU HAVE READ ALL THE
INSTRUCTIONS.
INITIAL INSTALLATION:
Before making AC connections,
refer to the AC requirements labeled on the charger. If your
charger is not equipped with an AC plug (a 220 volt model) have a qualified electrician install
one.
CAUTION: This charger must be connected to a dedicated 30 amp branch circuit
protected by a circuit breaker or fuse, in accordance with the National Electric
Code, ANSI/NFPA 70, and all local codes and ordinances.
GROUNDING INSTRUCTIONS:
This battery charger must be grounded to reduce the risk of electric shock. If the charger is
equipped with a grounding type plug, it must be plugged into a nominal 115 volt, 60 Hertz
circuit. If the charger is supplied with no plug, have a qualified service person install one.
WARNING: Improper connection of the equipment grounding conductor can result in a
risk of an electric shock. DO NOT USE THIS CHARGER ON A TWO
POLE UNGROUNDED OUTLET OR ATTEMPT TO BREAK OFF
THE GROUND PRONG FOR USE ON A RECEPTACLE OR
EXTENSION CORD NOT HAVING A GROUND.
The use of an extension cord with this charger should be avoided. The use of an improper
extension cord result in a risk of a fire or electric shock. If an extension cord must be used, make
sure it is in good condition. Use a three conductor cord no smaller than 12 AWG. And keep it as