Quick Charge QPAX36-240V/6A - Manual

QPAX36-240V/6A, MULTI SERIES Battery Charger
INTRODUCTION:
The Series Multi charger is designed to charge 18 - 120 cells in series at a 1 to 6 amp rate. The
charge rate is controlled by one infinite adjustable control knob.
WARNING: THIS CHARGER HAS THE POTENTIAL TO PRODUCE UP TO 300
VOLTS DC WHICH CAN BE LETHAL. EXERCISE EXTREME
CAUTION WHEN HANDLING LEADS. ALWAYS TURN POWER OFF
FIRST. THE BATTERY STRING ITSELF CAN CAUSE A SEVERE
SHOCK OR ELECTROCUTION IF BODY PARTS MAKE CONTACT
WITH THE BEGINNING AND END OF THE STRING.
WARNING: Do not use this charger on motorcycle batteries, nicad batteries, or gel
batteries. This charger has no voltage limit, charging these batteries could
cause an explosion resulting in bodily harm.
IMPORTANT: DO NOT USE THIS CHARGER UNTIL YOU HAVE READ ALL THE
INSTRUCTIONS.
INITIAL INSTALLATION:
This charger requires 220-230 volts input and is shipped without an AC cord cap. Have a
qualified electrician install one and a compatible AC receptacle.
GROUNDING INSTRUCTIONS:
WARNING: Improper connection of the equipment grounding conductor can result in a risk
of an electric shock. DO NOT USE THIS CHARGER ON A TWO POLE
UNGROUNDED OUTLET OR ATTEMPT TO BREAK OFF THE
GROUND PRONG FOR USE ON A RECEPTACLE OR EXTENSION
CORD NOT HAVING A GROUND.
CAUTION: To reduce the risk of fire, use this charger only on circuits provided with
a maximum of 20 ampere branch circuit protection (circuit breaker or fuse), in
accordance with the National Electric Code, ANSI/NFPA 70, and all local
codes and ordinances.
The use of an extension cord with this charger should be avoided. The use of an improper
extension cord could result in a risk of a fire or electric shock. If an extension cord must be used,
make sure it is in good condition. Use a three conductor cord no smaller than 14 AWG. And keep
it as short as possible. Locate all cords so that they will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
1