Ram Trucks 2009 1500 - Owner Manual - Manual (Page 431)

2. Using the wheel wrench, loosen, but do not remove,
the wheel nuts by turning them counterclockwise one
turn while the wheel is still on the ground.
3. Placement of the jack:
• When changing a front wheel, place the scissors jack
under the rear portion of the lower control arm as
shown below.
• Operate the jack using the jack drive tube and the
wheel wrench. The tube extension may be used but
is not required.
4X2 Jacking Location
4X4 Jacking Location
6
WHAT TO DO IN EMERGENCIES 429