Fuel filter/water separator — diesel only, Draining fuel/water separator, Fuel filter replacement — diesel only – Ram Trucks 2010 3500 - User Guide User Manual

Page 74: Maintaining your vehicle

Advertising
background image

FUEL FILTER/WATER SEPARATOR — DIESEL ONLY

Draining Fuel/Water Separator

• If the “Water in Fuel” indicator light

is illuminated and an audible chime is heard

five times, you should stop the engine and drain the water from the separator.

• The drain is located on the bottom of the Fuel Filter and Water Separator assembly

which is located on the driver's side of the engine.

• Turn the drain valve (located on the side of the filter) counterclockwise 1/4 turn, then

turn the ignition switch to the ON position to allow any accumulated water to drain.

• When clean fuel is visible, close the drain and switch the ignition to OFF.
• Refer to the Owner's Manual on the DVD for further details.

CAUTION!

• If the “Water In Fuel Indicator Light” remains on, DO NOT START the engine before

you drain water from the fuel filter to avoid engine damage.

• Do not drain the fuel/water separator filter when the engine is running.

• Diesel fuel will damage blacktop paving surfaces. Drain the filter into an

appropriate container.

Fuel Filter Replacement — Diesel Only

• With the engine off and a drain pan under the fuel filter drain hose, open the water

drain valve 1/4 turn counterclockwise and completely drain fuel and water into the
approved container.

• Close the water drain valve and remove the lid using a socket or strap wrench; rotate

counterclockwise for removal. Remove the used o-ring and discard it.

• Remove the used filter cartridge from the housing and dispose of according to your

local regulations.

• Wipe clean the sealing surfaces of the lid and housing and install the new o-ring into

ring groove on the filter housing and lubricate with clean engine oil.

• Install a new filter in the housing. Push down on the cartridge to ensure it is properly

seated.

Do not pre-fill the filter housing with fuel.

• Install the lid onto the housing and tighten to 22.5 ft lbs (30.5 Nm). Do not overtighten

the lid.

• Start the engine and confirm no leaks are present.

CAUTION!

• Diesel fuel will damage blacktop paving surfaces. Drain the filter into an

appropriate container.

• Do not prefill the fuel filter when installing a new fuel filter. There is a possibility

debris could be introduced into the fuel filter during this action. It is best to install
the filter dry and allow the in-tank lift pump to prime the fuel system.

MAINTAINING YOUR VEHICLE

72

Advertising
This manual is related to the following products: