Ram Trucks 2010 3500 - User Guide - Manual (Page 90)

Disclaimer:
• THE TIRE MANUFACTURER’S LIMITED
WARRANTY PROGRAM, THE DETAILS
OF WHICH CAN BE FOUND ON THE
OWNERS MANUAL DVD, THE TIRE
MANUFACTURER’S WEBSITE OR AT
ANY AUTHORIZED SERVICE CENTER
ARE IN LIEU OF ALL OTHER REMEDIES
OR WARRANTIES, EXPRESS OR
IMPLIED, ARISING BY LAW OR
OTHERWISE, INCLUDING FITNESS FOR
A PARTICULAR PURPOSE OR
MERCHANTABILITY. THE TIRE
MANUFACTURER EXPRESSLY
DISCLAIMS LIABILITY FOR INDIRECT,
SPECIAL, INCIDENTAL OR
CONSEQUENTIAL DAMAGES, LOST
PROFIT, LOSS OF BUSINESS, LOSS OF
GOODWILL, LOSS OF REPUTATION,
PUNITIVE OR ANY OTHER DAMAGE,
COST OR LOSS OF ANY KIND. SOME
STATES AND PROVINCES DO NOT
ALLOW THE EXCLUSION OR
LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE
ABOVE LIMITATION OR EXCLUSION
MAY NOT APPLY TO YOU.
WARNING!
NOTE: Refer to the Owner's Manual on
the DVD for complete warning
information that could prevent
accidents, injuries and even deaths.
WARNING!
Death, serious injury and/or property
damage may result from:
• Tire failure due to impact damage
and/or improper maintenance.
• Tires should be inspected regularly
by a qualified technician for signs
of damage, such as punctures,
impacts, under-inflation or
overloading.
(Continued)
WARNING! (Continued)
• Progressive air loss may result
from punctures, cuts, curbing,
impacts or partial bead unseating.
Some fitment causes for air loss are:
• Incomplete bead seating.
• Bead tearing caused by a machine
tool due to insufficient lubrication
or improper adjustment.
• Leaking valve core or rubber valve
components (these should be
replaced when problems are
detected and whenever tires are
replaced).
• Tire failure due to improper
repairs.
• See Rubber Manufacturer's
Association (RMA) established
repair procedures at www.rma.org
for information on proper repair
procedures. Never perform a
temporary repair or use an inner
tube as a substitute for a proper
repair. Only qualified persons
should repair tires.
• Explosion of tire/rim assembly due
to improper mounting.
• Only specially trained persons
should mount tires.
• Failure to mount tires on approved
rims.
• Failure to deflate single or dual
assemblies completely before
demounting.
Using Lift Kits
• Use of lift kits with some vehicle/tire
combinations can cause instability or
loss of control. When changing tire
sizes, always consult an installer for
optimum rim width and carefully
check vehicle/tire clearances.
CONSUMER ASSISTANCE
88