Ram Trucks 2012 С/V - Owner Manual - Manual (Page 588)

LIGHT BULBS – Exterior Bulb Number
Headlamp . . . . . . . . . . . . . . . . . . . . . . . . . . . . . H11
Fog Lamp – If Equipped . . . . . . . . . . . . . . . . PSX24W
Front Side Marker, Park/
Turn Signal . . . . . . . . . . . . . . . . . . 3757A or PY27/7W
Rear Tail, Stop, Turn Signal Lamp . . . . . . . . . . . . LED
(Serviced at Authorized Dealer)
Center High-Mounted Stop Lamp . . . . . . . . . . . . LED
(Serviced at Authorized Dealer)
Backup Lamp . . . . . . . . . . . . . . . . . . . . . . . . . . 3157
License . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 168
BULB REPLACEMENT
Headlamps
1. Raise the hood to access the rear of the headlamp
housing.
2. Slide the red lock tab rearward on the connector, then
depress the tab and remove the connector from the bulb.
3. Twist the headlamp bulb and pull the bulb from the
headlamp housing.
4. Install the new headlamp bulb and twist until locked
into the headlamp housing.
CAUTION!
Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.
5. Connect the wiring connector to bulb and slide red
lock tab forward.
586 MAINTAINING YOUR VEHICLE