Special additives, Fluid level check, Fluid level check – 5.7l engine – Ram Trucks 2013 Chassis Cab - Owner Manual User Manual

Page 424

Advertising
background image

Special Additives

The manufacturer strongly recommends against using
any special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered product and
its performance may be impaired by supplemental addi-
tives. Therefore, do not add any fluid additives to the
transmission. The only exception to this policy is the use
of special dyes for diagnosing fluid leaks. Avoid using
transmission sealers as they may adversely affect seals.

Fluid Level Check

Check the fluid level when the engine is fully warmed up
and the transmission fluid is at normal operating tem-
perature. Driving with an improper fluid level will
greatly reduce the life of the transmission and of the
fluid. Check the fluid level whenever the vehicle is
serviced.

Fluid Level Check – 5.7L Engine

It is best to check the fluid level when the transmission is
at normal operating temperature (170-180°F / 77-82°C) .
This normally occurs after at least 15 miles (25 km) of
driving. At normal operating temperature the fluid can-
not be held comfortably between the fingertips. You can
read the transmission sump temperature in the EVIC
display (see Electronic Vehicle Information Center [EVIC]
for further information).

Use the following procedure to check the transmission
fluid level properly:

1. Monitor the transmission temperature using the EVIC

display, and operate the vehicle as required to reach
the normal operating temperature.

2. Park the vehicle on level ground.

422

MAINTAINING YOUR VEHICLE

Advertising