Ram Trucks 2014 ProMaster Commercial - User Guide - Manual (Page 26)

Accel/Decel
To Increase Speed
• When the Electronic Speed Control is set, you can increase speed by tapping the
Speed Control lever up (+).
The speed increment shown is dependant on the speed of U.S. (mph) or Metric
(km/h) units:
U.S. Speed (mph)
• Tapping the Speed Control lever up (+) once will result in a 1 mph increase in
set speed. Each subsequent tap of the lever results in an increase of 1 mph.
• If the lever is continually help up, the set speed will continue to increase until
the lever is released, then the new set speed will be established.
Metric Speed (km/h)
• Tapping the Speed Control lever up (+) once will result in a 2 km/h increase in
set speed. Each subsequent tap of the lever results in an increase of 2 km/h.
• If the lever is continually help up, the set speed will continue to increase until
the lever is released, then the new set speed will be established.
To Decrease Speed
• When the Electronic Speed Control is set, you can decrease speed by tapping the
Speed Control lever down (-).
The speed decrement shown is dependant on the speed of U.S. (mph) or Metric
(km/h) units:
U.S. Speed (mph)
• Tapping the Speed Control lever down (-) once will result in a 1 mph decrease
in set speed. Each subsequent tap of the lever results in a decrease of 1 mph.
• If the lever is continually held down, the set speed will continue to decrease
until the lever is released, then the new set speed will be established.
Metric Speed (km/h)
• Tapping the Speed Control lever down (-) once will result in a 2 km/h decrease
in set speed. Each subsequent tap of the lever results in a decrease of 2 km/h.
• If the lever is continually held down, the set speed will continue to decrease
until the lever is released, then the new set speed will be established.
Resume
• To resume a previously set speed, push the RES button and release.
Cancel
• A soft tap on the brake pedal, pushing the RES button, or normal brake pressure
while slowing the vehicle will deactivate the Speed Control without erasing the set
speed memory.
OPERATING YOUR VEHICLE
24