RED ROCKET - Manual (Page 4)

COPYRIGHT © 2014 RED.COM, INC
RED ROCKET INSTALLATION INSTRUCTIONS
955-0035, REV-B | 4
SAFETY INSTRUCTIONS
Please read the following safety instructions very carefully before
attempting any installation and/or performing any work on the
RED ROCKET board.
If the RED ROCKET board is not used in compliance with the safety
instructions, the warranty and all resulting liability claims will be
void.
 DO NOT use the RED ROCKET board near water. Avoid expos-
ing your RED ROCKET board to moisture. The unit is not wa-
terproof, so contact with water could cause permanent dam-
age to the unit as well as electric shock and serious injury
to the user. DO NOT use the RED ROCKET board in the rain
or under other conditions with high moisture, and immediately
remove power source if the RED ROCKET board is exposed to
moisture.
WARNING: To reduce the risk of fire
or electric shock, do not expose the
RED ROCKET board to rain or moisture.
 DO NOT expose your RED ROCKET board to excessive vibra-
tion or impact (shock). Be careful not to drop your RED ROCKET
board. Internal mechanisms may be damaged by severe shock.
 DO NOT operate or store near any heat sources such as radia-
tors, heat registers, stoves, or any other apparatus that pro-
duce heat. Store in a protected, level and ventilated place.
Avoid exposure to temperature extremes, damp, severe vibra-
tion, strong magnetic fields, direct sunlight or local heat sourc-
es during storage. Recommended storage and usage tempera-
tures for your RED ROCKET board are:
‒ Operating range: 5°C to 40°C (41°F to 104°F)
‒ Storage range: -17°C to 70°C (-0°F to 158°F)
If there are any performance issues with your RED ROCKET
board when operating within this temperature range, please file
a support ticket on support.red.com .
 Only use the RED ROCKET board when it is in good working
order.
 The system in which you are trying to install the RED ROCKET
board usually works with voltages that can be hazardous to
your health. Never work on the system or access its interi-
or with any power cable attached and plugged into a power
source. Make sure the power supply is disconnected from the
components you intend to work on.
 Computer hardware contains components that are sensitive to
electrostatic discharge. If you touch them without precaution-
ary measures, they can be destroyed. Use a wrist strap con-
nected to ground when accessing electronic parts and take
care of grounding the video system. Avoid touching the com-
ponents of the computer system and the RED ROCKET board
whenever possible.
 Computer hardware contains components that are sensi-
tive to changing voltages. Connecting or disconnecting the
RED ROCKET board to or from peripheral hardware while any
system component is powered on may damage the hardware.
Power off all peripheral hardware before connecting or discon-
necting any component, including the RED ROCKET board.

The RED ROCKET board may not be misused, abused, physi-
cally damaged, neglected, exposed to fire, water or excessive
changes in the climate or temperature, or operated outside
maximum rating.
 Do not perform any changes or extensions to the RED ROCKET
board whatsoever.
CAUTION: Refer all service and repair to
qualified RED service personnel. To reduce
the risk of electric shock, and damage to
the RED ROCKET board, DO NOT attempt
to perform any servicing other than the
procedures that are recommended in the
operating instructions.