Sandia Aerospace STX 165 Installation Manual - Manual (Page 16)

1. Strip cable to dimensions shown. Do not nick braid or center conductor.
2. Solder contact to center conductor.
3. Flare braid and slide body assembly over contact and under braid. Th
en seat body assembly fi rmly onto contact. Th e cable may
have to be held in a clamping fi xture. Arrange braid uniformly around crimp stem. Slide crimp sleeve forward and crimp using
recommended crimp tool. Slide heat shrink froward and shrink ( as applicable.)
Note: tools can be purchased from Emerson at http://emersonconnectivity.com
J3
J2
Static Input Port
Antenna Connector
15
Figure 3-10
STX 165 Rear View
Figure 3-9
Antenna SMA Assembly