ScanTool 2000 ECUsim - Manual (Page 8)

8 ECUsim™ 2000 User Guide
3.0 Basic Operation
ECUsim 2000 comes with protocols unlocked according to the selection
you’ve made when placing the order, and is ready to be used out of the box.
3.1 Setup
To set up the simulator, follow these steps:
1. Use the configuration DIP switch to set the desired options.
2. Plug the power supply into an available electric outlet.
3. Plug the 12 volt end of the power supply into the power jack of the
simulator.
4. Connect the OBD connector of your OBD tester or OBD interface to
the DLC.
3.2 Using the Simulator
After the power is first applied, the green Power LED will turn on solid, and the
Link and MIL LEDs will turn on and off in sequence.
The Link light should be flashing or dimming as the messages are exchanged
between the tester and the simulator.
To generate a malfunction event, press the Fault button. Use the knobs to
adjust the values of the respective PIDs. Use the Configuration DIP switch to
configure protocol attributes for ISO 15765-4 and ISO 14230-4 (refer to Section
2.1, Interface Elements, for more information).
To display currently selected OBD protocol and for information about
switching protocols, see Section 5.0, Software Configuration.