Sceptre X325BV-FMDR User Manual
Page 48
- 48 -
www.SCEPTRE.com
SCEPTRE X325BV-FMDR User Manual
Problems
Solutions
TV’S UNIVERSAL
REMOTE CODE
This television follows SONY’s universal remote code. To find
the actual code you must read through your own universal
remote’s guide book.
TV CHANNELS ARE
BLOCKED
Check your auto lock function’s settings inside the OSD. You
may have locked up some channels but forgot about them.
Refer to page 32 for more instructions.
UNIVERSAL REMOTE
CODE
This TV follows SONY’s universal remote code. Please check
your hand book for SONY’s codes then apply them.
THE TV TURNS ON
OR OFF SLOWLY
AND THE SCREEN
SHOWS UP SLOWLY
This TV is a High Definition liquid crystal display panel TV. It
requires a few more seconds than normal TVs to power up
and show the picture.
NO SOUND ON PC
Make sure you have a 3.5 mm mini-jack cable connected from
your pc’s sound output to the TV’s VGA STEREO INPUT.
HDCP VIDEO SAYS
NO HDCP SUPPORT
Reboot your HDCP video device but turning them off and
unplugging the power cord. Wait up to 8 minutes to plug the
power back in to see if it works or not.
HDCP VIDEO HAS NO
AUDIO
Make sure you have a 3.5 mm mini-jack cable connected from
your HDCP video device’s sound output to the TV’s VGA
STEREO INPUT. If your HDCP video device uses RCA
AUDIO jacks, you’ll need to obtain a RCA audio converted into
3.5 mm mini-jack cable.
CANNOT GET
1920X1080 ON PC
VGA
Make sure the TV is recognized as plug and play monitor. Try
updating your video card’s drivers as well. If that does not
help, most likely you’ll need to upgrade your video card to a
newer one.
PICTURE IS
DISTORTED OR HAS
ABNORMAL SOUND
This might be from interference from large electrical
appliances, cars, motorcycles, or fluorescent lights. If the TV
is close to the wall, try moving the TV to another room in your
house to see if the problem still occurs.
PICTURE DOES NOT
COVER THE ENTIRE
SCREEN
If you’re using HDMI or a TV digital channel make sure you
use the ASPECT button to switch to 16:9 format. If you are
using VGA, use the AUTO ADJUST function to adjust to the
screen. Please Note : If you are using regular analog TV, AV,
or component in 480i resolution, use the ASPECT button to
switch to 16:9 in order to fill up the screen. Please Note : This
note this feature will distort the picture.
PICTURE QUALITY IS
HORRIBLE!!
For best image quality, view HD widescreen programs where
possible. If HD content is not available view “Standard
Definition” from a digital source. Standard, analog TV will
always be noticeable inferior to HD because your TV has
video that is many times better than old TV’s and so you can
see interference and deficiencies you did not KNOW you had.
PICTURE HAS
PIXELS THAT ARE
ALWAYS
DISPLAYING THE
SAME COLOR
Your TV is manufactured using an extremely high level of
precision technology, however, sometimes some pixels of your
TV may not display. Pixels defects within industry
specifications are inherent to this type of product and do not
constitute a defective product.
I CANNOT CHANGE
THE TIME MANUALLY
Your TV syncs time automatically according to your local TV
channel. This function only works while the TV’s tuner is
connected to an ANTENNA.